![]() Then, calculate the total number of results sets in the study. ![]() The general method below is to load the results from the db file using RESUME. I typically do not use a file header but one could insert that if desired. For a structural system in which I am interested in deformations, I typically like to a file format of “X Y Z UX UY UZ” where X, Y, Z are the coordinate locations and UX,UY,UZ are the deformations at each node in the named selection. ![]() Next, we insert a Commands (APDL) object into the Solutionīelow is the command snippet that we use to export the data. ![]() Then, we must make sure to set the output to save an mapdl db file to yes. One could use a set of faces or edges, vertices, or volumes. Here we have chosen to use a single face as the named selection. We begin by creating a Named Selection to define the regions of the model where we are interested in results. One could also use this in a thermal, modal, or transient structural with a few changes needed. In this static structural example, there are three time steps as we change the forces on the bracket. With a snippet one inserts a Commands (APDL) object in the solution and writes APDL code to perform the desired functions.īelow we use a simple example of an L-shaped bracket. ![]() One can right-click on a desired result and use Export, but that can be tedious if there a lot of results to save. Commonly, we need to save results from an Ansys Workbench study as a text file for post-processing in another program, such as Excel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |